Owners Manual

8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
Tools You Will Need
 It is recommended that you do
not install the wine cooler
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
 The rough cabinet opening
must be on a level floor area
and at least 28 11/16” deep
(72.9cm) by 23 3/4 ”(60.1cm)
wide. The opening should also
have a height of at least
69 8/16 ”(176.5cm).
The electrical outlet may be
positioned from within either
side of the adjacent cabinetry
, or
the rear of the shaded area (as
shown in Fig D).
 If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2”(3.81cm) diameter hole to
admit the power cord. If the cabi-
net wall is metal, the hole edge
must be covered with a bushing
or grommet.
Fig

D
Important˖ If the electrical outlet
is surface mounted (not flush)
within the enclosure, the depth
requirement for the installation
may be affected.
stnemeriuqeR lacirtcelE
-noc eb tsum ecnailppa ehT
laudividni na ot detcen
lacirtcele dednuorg ylreporp
ro 51 a yb detcetorp ,teltuo
rekaerb tiucric erepma 02
.esuf yaled emit ro
FigE
}
}
}
}
69
8
/16
”
/
176.5cm
28
11
/16
/
72.9cm
Electrical
Access:1-1/2”/
3.81cm
23
3
/4
”
/
60.1cm
Cabinets
must be
square
and
plumb.
”
}
Top:2-1/2”/ 6.5cm
The top of cabinet should have
a deepness of at least
2-1/2”(6.5cm).
While performing
installations described
in this section, gloves,
safety glasses or
goggles should be
worn.
Tape measure
Carpenter square
Electric drill with hole bit
Gloves
Level
Safety goggles
Flashlight
)25<2856$)(7<
127(
This unit is front breathing.
Do not block the front air vent.
Blockage of the vent will result in
high operating temperatures and
system failure. (Fig.E)
*The listed depth requirement for the installation is assuming
that the electrical outlet is located in theadjacent cabinetry or
is flush mounted in the rear wall, not surface mounted in the
enclosure. Fig.D