Owners Manual

11
Trouble Shooting
Problem Possible Cause What to do
No Power.
A fuse in your home may
Replace fuse or reset circuit breaker.be
blown or the circuit
Plug not fully inserted into
Make sure the 3-prong plug on thewall
outlet
Door(s) not shut properly Ensure that the doors are fully closed
only as needed and for short periods
Exhaust vent is obstructed Verify there is nothing blocking the
Recently added a large
Limit the quantity of warm items
Condensation on the
High humidity conditions The condensation will subside once
Door(s) not shut properly Ensure that the doors are fully closed
against the cabinets. Open the doors
only as needed and for short periods
breaker
tripped
Power surge
Unplug the beverage center, wait a few
too High
or
opened excessively and that the gaskets are sealing
against the cabinet. Open the doors
cans to the cabinet
of time
cabinet and/or doors
in the home humidity conditions return to normal
quantity
of warm bottles or
being introduced to the cabinet.
front mounted exhausting vent
of time
Adjust if neccessary
Cabinet Temperature Temperature
Verify the temperature control setting
beverage center is fully inserted into outlet
seconds and then plug it back in
Occasionally, a problem is minor and a service call may not be necessary - use this trouble shooting
guide for a possible solution. If the unit continues to operate improperly, call an authorized service
depot or toll free at 1-844-455-6097
or opened excessively and that the gaskets are sealing
Alarm Beeping and “HI”
is displayed on the
control panel
not as set
Recently added a large
cans to the cabinet
quantity
of warm bottles or
Limit the quantity warm items
being introduced to the cabinet.
of
The door is not closed tightly Be sure the door is closed tightly
System leak, Evaporator fan
failure, compressor fan failure
Contact service center.
To stop beeping, unplug the unit
Alarm Beeping and “LO”
is displayed on the
control panel
Sensor Failure, Evaporator
temperature is too low
Contact service center.
To stop beeping, unplug the unit