Setup Guide

Installation Instructions
There are two methods that can be used to install the Danby Parcel Guard, depending on what
installation location is available. Decide which option is best for your chosen location and follow the
steps below.
A. Secured through the rear
1. Use a power drill and a 1/4” drill bit to create holes in the marked locations on the back wall
of the Danby Parcel Guard.
2. Place the Danby Parcel Guard against the wall or structure that it will be secured to.
3. Use a pen or pencil to mark the hole locations through the drilled holes.
4. Move the Danby Parcel Guard out of the way and then use a power drill and a 1/4” drill bit
to create
guide holes for the bolts or screws, at least 2.5” deep for wood screws and at least 3.75”
deep for concrete bolts.
5. Replace the Danby Parcel Guard and insert the wood screws or concrete bolts with washers
into the
holes. Use a wrench to tighten the wood screw. Tighten the nut on the concrete bolts and
the sleeves will expand to secure the bolt.
B. Secured through the bottom
1. Remove the platform at the bottom of the Parcel Guard. Two holes are pre-drilled in the
bottom of the box.
2. Place the Danby Parcel Guard on the floor or structure that it will be secured to.
3. Use a pen or pencil to mark the hole locations through the drilled holes.
4. Move the Danby Parcel Guard out of the way and then use a power drill and a 1/4” drill bit
to create guide holes for the bolts or screws, at least 2.5” deep for wood screws and at least
3.75” deep for concrete bolts.
5. Replace the Danby Parcel Guard and insert the wood screws or concrete bolts with washers
into the holes. Use a wrench to tighten the wood screw. Tighten the nut on the concrete
bolts and the sleeves will expand to secure the bolt.