Owner's Manual

BACKGUARD INSTALLATION

The backguard acts as a heat vent for the oven and

must be installed before the appliance is used.

1. Install three screws in the back of the appliance

but do not tighten completely. The backguard

will slide onto the screws.

2. There are three holes on the back of the

backguard that will slide over the screws

installed in step 1. These holes may be hidden

by a rear panel.

3. Install the backguard from the top. Ensure that

the holes are over the screws then push toward

the front of the appliance.

4. Install 4 screws in the back to secure the

backguard.

INSTALLATION INSTRUCTIONS