Specifications

Installation Preparation
PREPARE THE LOCATION
DEPTH: 24"(610mm)
WIDTH: 18 (460mm)"
HEIGHT: 33"~35-1/2"(840~900mm)
UNIT DIMENSIONS
B) air gap with disposer
D) disposer
DEPTH: 23"(580mm)
WIDTH: 18"(450mm)
HEIGHT: 33"~35"
(840~890mm)
Area of Plumbing and
Electric Service
6"
Floor must be Even
With Room Floor
Min. 18"
33 35-1/2
Underside of
Countertop to Floor
""
Min. 24"
Area of Pipe or wires
18"
Min.
33 ~35""
18"
23"
If you install the dishwasher
into a corner, allow 2" min.
Clearance between dishwasher
and adjacent cabinet, wall or
other appliances. Allow 22"
min. Clearance from the front
of the dishwasher for door
opening.
TYPE OF DRAIN CONNECTION:
18"
Min.
A) air gap with waste tee
C) waste tee
2" Minimum Clearance
22"
For ease of installation, the dishwasher should be
installed as close as possible to the kitchen sink
(plumbing) to facilitate incoming water and drain supply
lines. Note:
Note:
Built-in dishwashers must be completely
enclosed on all exposed sides; (top, sides and rear)
2
CORNER INSTALLATION
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
The dishwasher comes with a factory installed drain hose.
Drill 2” diameter hole to allow the drain hose to pass thr
ough
the cabinet and connect to drain. (under
sink)
Review the different ways of connect
ing the dishwasher
to the
drain system, (See Figs 4, 5, 6, 7) and choose a method that b
est
suits your (application)
needs. Local codes may r
equire that you
install an air
gap kit (not include) on your
dishwasher, check
with a qualified plumber
if in doubt.