Owner's Manual

There are two ways to remove collected water:
1. Use the bucket
When the unit is off and the bucket is full, the unit will beep 8 times, the
bucket full indicator light will fl ash, and the digital display shows P2.
When the unit is on and the bucket is full, the compressor turns off and
the fan turns off after drying the water off the condenser for 30 seconds.
The unit will then beep 8 times and the bucket full indicator light will
fl ash, and the digital display shows P2.
To empty the full bucket, slowly pull out the bucket. Grip the left and
right handles securely, and carefully pull it straight out so water does
not spill. Do not put the tank on the fl oor because the bottom of the
bucket is uneven. Otherwise the bucket will fall and cause water to spill.
Discard the water and return the bucket to the unit. The bucket must
be placed and properly positioned for the dehumidifi er to operate. The
machine will restart when the bucket is restored in its correct position.
Note: When you remove the bucket, do not touch any parts inside of
the unit. Doing so may damage the product. Be sure to push the bucket
gently all the way into the unit. Banging the bucket against anything or
failing to push it in securely may cause the unit not to operate. When
you remove the bucket, if there is some water inside the unit you must
dry it. The power button fl ashes when the bucket is not properly in
place.
2. Continuous draining:
Water can be automatically emptied into a fl oor drain by attaching the
unit to an ID ≥ 5/16” water hose with a ID:M=1 female threaded end
(not included, a standard garden hose works well). Install the drain
hose. The adaptor is found in the accessory bag located in the bucket.
Remove the plastic cover from the back drain outlet of the unit and set it
aside. Remove the bucket, then insert the drain hose through the drain
outlet of the unit and securely press it into the connector on the front of
the unit.
Install the female threaded end of the water hose into the adaptor A
(see B4), then lead the water hose to the fl oor drain or a suitable drain-
age facility. Make sure the hose is secure so there are no leaks. Direct
the hose toward the drain, making sure that there are no kinks that will
stop the water from fl owing. Place the end of the hose into the drain
and make sure the end of the hose is level or declining to let the water
fl ow smoothly. Place the bucket back in the unit and make sure that it is
located correctly. Select the desired humidity setting and fan speed on
the unit for continuous draining to start.
Operating Instructions
REMOVING COLLECTED WATER
9
1. Pull out the bucket a little.
2. Hold both sides of the
bucket with even strength and
pull it out from the unit.
3. Pour the water out.
Remove the plastic
cover by turning it
counter-clockwise.
Drain hose
If the pump hose drops when you
remove the bucket, ensure it is reinstalled properly.