Owner's Manual

5
Operating Instructions
CONTROL PANEL
INSTRUCTIONS
NOTE: The control panel of the unit you purchased may be slightly
different according to the models.
8
1
2
3
45
6
7
Clean filter
indicator light
Low fan
indicator light
High fan
indicator light
Timer on/off
indicator light
Remote signal receptor
Bucket full
indicator light
Continuous
operation on
indicator light
Power on
indicator light
HEAT Normal
on
off
Time
Cont. Power
Full
Turbo
Remote
signal
receptor
Heat
Fan
Timer
Cont.
Power
CONTROLS
When you push the button to change operation
modes, the unit will make a beeping sound to indicate
that it is changing modes.
1) HEAT BUTTON
Press this button to activate the electrical heating mode.
Press it again to stop the funtion.
NOTE: DEHUMIDIFYING model only has no HEAT button
and heating feature.
2) FAN BUTTON
Control the fan speed. Press to select either High or
Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set the
fan control to Normal.
3,4) ( + / - ) buttons
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
• For drier air, press the (-) button and set to a lower
percent value(%).
• For damper air, press the (+) button and set a higher
percent value(%).
Timer Set Control Buttons
Use the Up/Down buttons to set the Auto start and
Auto stop time from 0.0 to 24.
Temperature Set Control buttons
Use the Up/Down pads to set the desired temperature
under the electrical heating mode from 17°C(62°F) - 30°C
(86°F).
5) Timer Button
Press to initiate the Auto start and Auto stop feature, in
conjuction with the (+) and (-) keys.
6) Continue Button
Press to activate the continuous dehumidifying operation
and dehumidifying operation.