Quick Start Guide

Call us 1-800-263-2629
[e-mail]
SETUP
OPERATING THE DEVICE
UNBOX THE DEHUMIDIFIER
Take out the device from its packaging and
allow to stand upright for 6 hours particularly
if the device was placed on its back or side.
Connect the power cord buckle in the bucket
to the back of the unit.
Open water bucket, remove the tape or
Styrofoam from bucket float. (Unit will not
work otherwise).
POWER THE DEHUMIDIFIER
3
Plug the unit into an electrical socket outlet with earth
connection. Do not plug to a multiple socket outlet that
is being used for other electrical appliances.
When first using the dehumidifier, operate the unit
continuously for 24 hours. Make sure the plastic cover
of the continuous drain hose outlet is installed properly
so there are no leaks.
Note: The dehumidifier will not start unless the set humidity
is lower than the ambient humidity. It is recommended in
normal conditions to set the humidity between 45-45%.
POSITIONING THE DEHUMIDIFIER
2
Ensure that the device is placed on a smooth,
level floor that is strong enough to support the
appliance with a full bucket of water.
Allow at least 20cm of air space on all sides of
the unit for good air circulation (at least 40cm
of air space on air outlet).
For eectiveness, this is to be used in enclosed
spaces only.
Please refer to the Owners Manual.
QUICK-START GUIDE FOR DEHUMIDIFIERS:
DDR020BJWDB | DDR030BJWDB | DDR040BJWDB | DDR050BJWDB