Use and Care Manual

Installation Instructions

3) Completing the Installation (cont)

• Carefully place the air conditioner into the window with the “L” shaped

mounting bracket (on top) positioned in front of the upper window sash.

The bottom of the cabinet should be positioned on the “recessed” portion

of the window frame. Pull the window down until it rests just behind the

front flange of the (top) “L” shaped mounting bracket (See Fig. 5).

• Expand the shutter frames (fully) on each side and secure the top of the

frames to the window sash using one 1/2” screw on each side and one in

the “L” shaped mounting bracket (Fig. 5).

• Secure the shutter clamp on each side of the lower part of the shutter and

secure to the window sill using one 1/2” screw on each side (Fig. 5).

• Place the second foam sealing strip to fit the opening between the inside

and outside windows, then attach the safety lock to the outside window

frame using one 1/2” screw (See Fig. 6).

Fig. 7 Measure the tilt angle from the cabinet’s edge

WINDOW

: approximately 3/4” to 1” for DAC080EB2GDB

Measure the tilt angle from the cabinet’s edge. The distance H should be approximately

3/4” to 1” for DAC080EB2GDB. The distance H should be approximately 1” to 1 3/8” for

DAC100EB2GDB and DAC120EB2GDB.

H: approximately 1” to 1 3/8” for DAC100EB2GDB

DAC120EB2GDB

Window sash

“L” Shaped

Mounting

Bracket

Shutter clamps

1/2” screws

Fig. 5

Safety Lock

1/2” screw

Foam

(adhesive)

Seal

Fig. 6

PLEASE NOTE: Window applications come in a variety of different styles. Therefore, it may

After proper installation, condensed water should not drain from the overflow drain hole during

normal use. If you notice water leaking out , check the angle of tilt, and make any necessary

adjustments. However, on a very humid day, water leakage can occur – this is normal.

be necessary to modify or improvise your particular installation.

Fig. 7.

is tilted downwards to the outside, about 3° to 4°, as shown in

Check that the air conditioner