User Manual
4 5
Wiring
Set up your Universal Module according to this schematic.
Use relay 1 before relay 2 if possible.
Click commands
You can congure the Universal Module via the button found in
the small hole on the module. When you get to the setting you
want, wait for 5 seconds and the Universal Module will react. If you
make a wrong number of clicks, just stop at an unmarked number
of clicks and wait for 5 seconds. The LED will ash red.
Clicks Color Activity
1 Green Inclusion/exclusion mode
This command is for setting up the Universal Module with a smart home gateway
such as Z-Wave. The Universal Module will respond by blinking green. Now the
module is in inclusion/exclusion mode and you have 30 seconds to pair or unpair it
with a gateway.
10 Red Reset the Danalock
Resets all settings on the Universal Module. The Universal Module will respond by
blinking red.
Power output: Ground
Power input: Ground
Power output: 12-24 V DC max. 100 mA
Relay 2: Normally open
Relay 2: Common
Relay 2: Normally closed
Relay 1: Normally open
Relay 1: Common
Relay 1: Normally closed
Power input: 12-24 V DC min. 500 mA
Universal Module V3