Installation manual

Safety Instructions
Only qualified personnel are permitted to transport, assembly, commission, and maintenance this
equipment. Properly qualified personnel are persons who are familiar with the transport, assembly,
installation, commissioning and operation of motors, and who have the appropriate qualifications for
their jobs. The qualified personnel must know and observe the following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
• Read all available documentation before assembly and commissioning. Incorrect handling of
products in this manual can result in injury and damage to persons and machinery. Strictly
adhere to the technical information on the installation requirements.
• It is vital to ensure that all system components are connected to earth ground. Electrical safety
is impossible without a low-resistance earth connection.
• The SERVOSTAR
®
product contains electro-statically sensitive components that can be
damaged by incorrect handling. Discharge yourself before t
ouching the product. Avoid contact
with high insulating materials (artificial fabrics, plastic film, etc.). Place the product on a
conductive surface.
• During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards
that could possibility cause severe damage to health or the product.
• In operation, depending on the degree of enclosure protection, the product can have bare
components that are live or have hot surfaces. Control and power cables can carry a high
voltage even when the motor is not rotating.
• Never pull out or plug in the product while the system is live. There is a danger of electric
arcing and danger to persons and contacts.
• After powering down the product, wait at least ten minutes before touching live sections of the
equipment or undoing connections (e.g., contacts, screwed connections). Capacitors can store
dangerous voltages for long periods of time after power has been switched off. To be safe,
measure the contact points with a meter before touching.
When these symbols are seen in this manual, be alert to the potential for personal injury. Follow the
recommended precautions and safe operating practices included with the alert symbols. Safety
notices in this manual provide important information. Read and be familiar with these instructions
before attempting installation, operation, or maintenance. The purpose of this section is to alert users
to possible safety hazards associated with this equipment and the precautions that need to be taken to
reduce the risk of perso
nal injury and damage to the equipment. Failure to observe these precautions
could result in serious bodily injury, damage to the equipment, or operational difficulty.
• The safety-alert symbols are:
Warning Alerts users to potential physical danger or harm. Failure to
follow warning notices could result in personal injury or death.
Caution Directs attention to general precautions, which if not followed,
could result in personal injury and/or equipment damage.
Note Highlights information critical to your understanding or use of the
product.