Installation manual

Danaher Motion Kollmorgen Read Before Installing
SERVOSTAR
®
S and SERVOSTAR
®
CD Series 2
13. Install MOTIONLINK on the PC.
Startup processes can cause motor motion. Be certain that all
applicable safety precautions are taken to ensure that no harm to
personal or machine can occur.
14. Using the Startup Wizard in MOTIONLINK:
A. Configure the SERVOSTAR S or SERVOSTAR CD for your
particular motor, if this was not done at the factory. Refer to the
MOTIONLINK Startup Wizard.
B. Enable the system.
Use As Directed
The restrictions for proper use of a SERVOSTAR S or SERVOSTAR CD
system are:
• These amplifiers are components that are built into electrical equipment or
machines and can only be commissioned as integral components of such
equipment.
• The servo amplifiers are to be used only on earthed, three-phase industrial
mains supply networks (TN-system, TT-system with earthed neutral point).
• The servo amplifiers must not be operated on power supply networks
without an earth or with an asymmetrical earth.
• If the servo amplifiers are used in residential areas, or in business or
commercial premises, you must implement additional filtering measures.
• The servo amplifiers are only intended to drive specific brushless
synchronous servomotors from Danaher Motion Kollmorgen, with closed-
loop control of torque, speed, and position. The rated voltage of the motors
must be at least as high as the DC-link voltage of the servo amplifier.
• The servo amplifiers may only be operated in a closed switch gear cabinet,
taking into account the ambient conditions defined in the environmental
specifications.
• Danaher Motion Kollmorgen guarantees the conformance of the servo
amplifiers with the standards for industrial areas stated in the front of this
manual only if Danaher Motion Kollmorgen delivers the components
(motors, cables, amplifiers etc).