Installation manual

Danaher Motion Kollmorgen 08/04 System Communication
SERVOSTAR S Installation M-SS-001-01 Rev. T 49
5.4.2 RUNNING THE PROGRAM
Go to your Start/Programs listing and select SERVOSTAR
MOTIONLINK from the menu (or click on the SERVOSTAR
MOTIONLINK icon if loaded on the desktop).
5.5 Using MOTIONLINK
MOTIONLINK gives you three methods to configure the drive. The
first uses the Startup screen and is the easiest and most highly
recommended approach. Its main purpose is for initial startups. The
second approach allows you to more indirectly perform the same
configuration as the first using the Main
MOTIONLINK screen. This
method is most convenient when corrections to an existing
configuration are needed. The third method uses the Terminal
Mode screen to directly set (or monitor) values for the same
variables and commands that the other two methods configure
through a more friendly user interface. You can gain a more
thorough understanding of the SERVO
STAR drive, MOTIONLINK,
and its variable and command set by using the context-sensitive
Help (F1) provided in
MOTIONLINK.
5.5.1 MOTIONLINK STARTUP WIZARD
This screen appears the first time MOTIONLINK is run on a PC
(and any time after should you leave it selected). It is designed to
guide you through a step-by-step approach to configure a drive.
Click the START button on the first user screen and walk through
the complete sequence of buttons provided to set the drive, motor,
and application (Opmode, Tune, Backup, Go) variable parameters.
Should you de-activate this screen, it can be reactivated by
going to the Main MOTIONLINK screen, pulling down the
Configuration menu, and selecting the New Drive (123) option.
Startup Wizard