Installation manual

Safety Instructions
Only qualified personnel are permitted to transport, assembly, commission, and
maintenance this equipment. Properly qualified personnel are persons who are
familiar with the transport, assembly, installation, commissioning and operation of
motors, and who have the appropriate qualifications for their jobs. The qualified
personnel must know and observe the standards and regulations of IEC 364
resp. CENELEC HD 384 or DIN VDE 0100 IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
− Read all available documentation before assembly and commissioning.
Incorrect handling of products in this manual can result in injury and damage
to persons and machinery. Strictly adhere to the technical information on the
installation requirements.
− It is vital to ensure that all system components are connected to earth
ground. Electrical safety is impossible without a low-resistance earth
connection.
− The SERVOSTAR
®
product contains electro-statically sensitive components
that can be damaged by incorrect handling. Discharge yourself before
touching the product. Avoid contact with high insulating materials (artificial
fabrics, plastic film, etc.). Place the product on a conductive surface.
− During operation keep all covers and cabinet doors shut. Otherwise, there
are deadly hazards that could possibility cause severe damage to health or
the product.
− During operation, depending on the degree of enclosure protection, the
product can have bare components that are live or have hot surfaces.
Control and power cables can carry high voltage even when the motor is not
rotating.
− Never pull out or plug in the product while the system is live. There is a
danger of electric arcing and danger to persons and contacts.
− After powering down the product, wait at least ten minutes before touching
live sections of the equipment or undoing connections (e.g., contacts,
screwed connections). Capacitors can store dangerous voltages for long
periods of time after power has been switched off. To be safe, measure the
contact points with a meter before touching.
When alert symbols are seen in this manual, be alert to the potential for personal
injury. Follow the recommended precautions and safe operating practices
included with the alert symbols. Safety notices in this manual provide important
information. Read and be familiar with these instructions before attempting
installation, operation, or maintenance. The purpose of this section is to alert
users to possible safety hazards associated with this equipment and the
precautions that need to be taken to reduce the risk of personal injury and
damage to the equipment. Failure to observe these precautions could result in
serious bodily injury, damage to the equipment, or operational difficulty.