Installation manual

Wiring 08/04 Danaher Motion Kollmorgen
26 M-SS-001-01 Rev. T SERVOSTAR S Installation
Note 15
Control logic input can be tapped directly off the main
line input. If this source is used, the main line power is
lost and all communication functions to the drive cease.
Note 16
See the SERVOSTAR Sx Hardware Specifications and
the BUS Module Hardware Specifications for spade
terminal sizes.
Note 17
This system is suitable for use on a circuit capable of
delivering not more than 5000 A
RMS
(symmetrical) and
240 V maximum.
4.6.1 BUS MODULES
4.6.1.1. PA08, 14, or 28 Wiring Diagram
CUSTOMER
SUPPLIED
FUSING
SYSTEM POWER
L1
L2
L3
EXTERNAL
REGEN RESISTOR
FAULT CONTACTS
OVERLOAD RELAY
MOMENTARY
PUSHBUTTON
TO ENERGIZE
MAIN POWER.
E-STOP
+15 V
- 15 V
+ 8 V
DC COMMON
DC BUS OK
BUS MODULE
C7
1
2
3
4
1
2
C6
C8
1
2
3
FAULT CONTACT
LOGIC
OUTPUT
BUS +
BUS -
(SEE NOTE 4)
(SEE NOTE 7)
(SEE NOTE 5)
PA 08/14/28
(SEE NOTE 3)
LA
LB
LC
NORMALLY OPEN
AUXILLIARY
POWER CONTACT
FROM
MAIN POWER
CONTACTOR
(SEE NOTE 9)
NOT AVAILABLE
ON PA08
(SEE NOTE 2)
(SEE
NOTE 8)
REGEN
NOT AVAILABLE
ON PA08
MAIN POWER CONTACTOR
(SEE
NOTE 13)
(SEE NOTE 14)
(SEE NOTE 10)
STAR
POINT
TO STAR POINT
DO NOT GROUND
SHIELD TO
STAR POINT
(SEE NOTE 15
(SEE NOTE 1)
SHIELD
CONNECTOR C8
(SEE NOTE 16)
PA08 115/230 VAC PA14 115 VAC PA28 230 VAC
INPUT FILTER
INPUT
FILTER
(SEE NOTE 14)
ON PA08
NOT AVAILABLE
To Sx Drive
Connector C5
SEE NOTE 6
To Sx Drive BUS +
To Sx Drive BUS -