Installation manual

Danaher Motion Kollmorgen 08/04 Unpacking and Inspecting
SERVOSTAR S Installation M-SS-001-01 Rev. T 3
2 UNPACKING AND INSPECTING
Electronic components in this amplifier are design hardened to
reduce static sensitivity. However, proper procedures should be
used when handling.
Remove all packing material and equipment from the shipping
container. Be aware that some connector kits and other equipment
pieces may be very small and can be accidentally discarded if care
is not taken when unpacking the equipment. Do not dispose of
shipping materials until the packing list has been checked.
Upon receipt of the equipment, inspect components to ensure that
no damage has occurred in shipment. If damage is detected, notify
the carrier immediately. Check all shipping material for connector
kits, manuals, diskettes, and other small pieces of equipment.
2.1 Bus Module Model Numbers
9 8 A-5 8 9
P A 0 8 0 0
Unit Manufactured
Year Manufactured
ServoSTAR® Bus Module
Rated Current (Amps):
08, 14, 28, 50, 75, 85, LM
Hardware Variations
00 - Standard
Month Manufactured
A - January
B - February
L - December
:
: