Installation manual

Read Before Installing 08/04 Danaher Motion Kollmorgen
2 M-SS-001-01 Rev. T SERVOSTAR S Installation
1. Using the Startup Wizard in MOTIONLINK:
A. Configure the SERVOSTAR S for your particular motor, if
this was not done at the factory. Refer to the
MOTIONLINK Startup Wizard.
B. Enable the system.
1.1 Use As Directed
The restrictions for proper use of a SERVOSTAR S system are:
− The amplifiers are components that are built into electrical
equipment or machines and can only be commissioned as
integral components of such equipment.
− The servo amplifiers are to be used only on earthed, three-
phase industrial main supply networks (TN-system, TT-system
with earthed neutral point).
− The servo amplifiers must not be operated on power supply
networks without an earth or with an asymmetrical earth.
− If the servo amplifiers are used in residential areas, or in
business or commercial premises, you must implement
additional filtering measures.
− The servo amplifiers are only intended to drive specific
brushless synchronous servomotors from Danaher Motion with
closed-loop control of torque, speed, and position. The rated
voltage of the motors must be at least as high as the DC-link
voltage of the servo amplifier.
− The servo amplifiers may only be operated in a closed switch
gear cabinet, taking into account the ambient conditions
defined in the environmental specifications.
Danaher Motion guarantees the conformance of the servo
amplifiers with the standards for industrial areas stated in the front
of this manual only if Danaher Motion delivers the components
(motors, cables, amplifiers etc).