Product manual

Wiring the Drive 05/2008 Danaher Motion
58 S200-VTS Product Manual
6.8.1.1 Status LED
The Status LED is located below the Serial Port connector located at J5. Please see the
Drive
Fault Codes section for descriptions.
6.8.2 Serial Interface Specification
Parameter Specification
Baud rate
19,200
Electrical Interface
RS-232, Full duplex
Transfer format UART, 1 start bit (mark), 8 data bits, odd parity bit
and 1 stop bit (space).
6.8.3 RS-232 Wiring
Cable wiring diagrams for connecting to either 9 or 25-pin serial ports of most computers are
also shown.
NOTE
Pinouts vary among computer manufacturers. Check the
hardware reference manual for your machine before wiring.
25 Pin Female
3
2
7
5
2
3
To PC
To J5
on Drive
To J5
on Drive
2
3
5
5
2
3
9 Pin Female
To PC