Product manual

Danaher Motion 05/2008 Wiring the Drive
S200-VTS Product Manual 51
6.7.2 General Purpose Outputs
General
Purpose
Outputs
J4-6,7
DOUT1
(FAULT)
J4-8,9
DOUT2
( RUN )
DOUT1 and DOUT2 are optically isolated outputs that
provide information about the state of the drive. The
outputs are Darlington phototransistors with a 33 V zener
diode wired in parallel to clamp voltage transients.
33V
33V
J4-6
DOUT1-
J4-7
DOUT1+ (FAULT)
J4-8
DOUT2-
J4-9
DOUT2+ (RUN)
The following table lists the maximum output rating.
Maximum Voltage
30 VDC
Maximum Current
50 mA
V
ON
1.0 V at 10 mA
1.2 V at 50 mA
I
OFF
5 µA
Response Time
1 ms
Clamp Voltage
33 V (nominal)
CAUTION
The outputs are not short circuit protected. Configure the application
to ensure the maximum current is not exceeded.