Installation manual

2
Copyright Information
© Copyright 2006 Danaher Motion – All rights reserved.
Printed in the United States of America
Notice
Not for use or disclosure outside of Danaher Motion except under written agreement. All rights are reserved. No part of this book shall be
reproduced, stored in retrieval form, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise without the
written permission from the publisher. While every precaution has been taken, the publisher assumes no responsibility for errors or omissions.
Neither is any liability assumed for damages resulting from the use of the information contained herein.
This document is proprietary information of Danaher Motion that is furnished for customer use ONLY. Information in this document is subject
to change without notice and does not represent a commitment on the part of Danaher Motion. Therefore, information contained in this manual
may be updated from time-to-time due to product improvements, etc., and may not conform in every respect to former issues.
Danaher Motion reserves the right to make engineering refinements on all its products. Such refinements may affect information in instructions.
Safety
WARNING
READ these instructions before connecting power. Damage can result
from MISWIRING at the power terminals.
DANGEROUS voltages are present on power input and motor output
terminals.
Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment. Properly
qualified personnel are persons who are familiar with the transport, assembly, installation, commissioning and
operation of motors, and who have the appropriate qualifications for their jobs.
Read all available documentation before assembling and using. Incorrect handling of products described in this
manual can result in injury and damage to people and/or machinery. Strictly adhere to the technical information
regarding installation requirements.
Keep all covers and cabinet doors shut during operation.
Be aware that during operation, the product has electrically charged components and hot surfaces. Control and power cables can carry a
high voltage, even when the motor is not rotating.
Never disconnect or connect the product while the power source is energized.
After removing the power source from the equipment, wait at least 5 minutes before touching or disconnecting sections of the equipment
that normally carry electrical charges (e.g., capacitors, contacts, screw connections). To be safe, measure the electrical contact points to
each other and to electrical safety earth with a meter before touching the equipment.