Installation manual

Jog the Motor

Select Status in the file tree on the left side of S200 Tools.

WARNING

Before turning the motor on, be sure the motor is safe to move and that the

motor is clear to turn with no obstructions.

Enable the drive (turn on input 1). You can verify that the drive is enabled if you see the green light at the

bottom of your screen (circled in red in Figure N.)

Figure N

Check the Fault Status and make sure it indicates “No Fault.” (Highlighted by the red rectangle in Figure

N.) If a fault is indicated, refer to the fault section “Chapter 11 Diagnostics and Troubleshooting” of the

“S200 High Performance Compact Brushless Servo Drives SynqNet and Base Units” located under

http://www.danahermotion.com/documents