Installation manual

11
3) For the S200 Base unit, select Serial as the Communications Mode and select the
appropriate COM port. Note: Leave the baud rate at the 19200 default.
Figure M
If you do not know which type of drive is connected, click the Test button. The returned message
will either say that there is no connection, or tell you that the connected node is NOT an S200
drive. If there is no connection, confirm that you have an S200 drive at check connections. If you
do not have an S200 drive, the software will not work.
The S200 Base Unit drives support SFD motor feedback that communicates motor identification to
the drive allowing automatic configuration. If other feedback devices are used, please consult the
complete manual for setup details.