Installation manual

Appendix B - Regulatory Information 07/06 Danaher Motion
91 S200 Position Node with CANOpen/ DeviceNet
APPENDIX B - REGULATORY INFORMATION
B.1 CONFORMANCE REQUIREMENTS
The equipment described herein has been developed, produced, tested and documented in
accordance with the corresponding standards. During use conforming with requirements, the
equipment is not dangerous for people or equipment. Use conforming with requirements means
that the safety recommendations and warnings detailed in this manual are complied with and
that the applicable regulations for safety (machine directives, etc.) and noise suppression (EMC
Directives) are observed while operating the drive. At the end of its lifetime, dispose of or
recycle the drive according to the regulations applicable at that time.
B.2 CE APPROVAL
The CE initials confirm that the S200 drives satisfy all requirements of CE Directives. However,
the equipment is not ready to operate without additional installations (cable, motor, etc.). Thus,
all necessary tests and measurements had to be made on a typical installation. The test
installation with all peripheral devices, as well as the test results and measurements are
recorded in detail in documentation that is available from the manufacturer on request.
B.3 CE EMC COMPLIANCE
NOTE
If the connection method on your machine is different from the ones
pictured in this manual, or in the event of use of components other than
those specified, adherence to CE interference limit values cannot be
guaranteed.
The machine builder should incorporate good EMC installation and
wiring practices in the machine design. Some machine designs require
more EMC consideration than others. For example, a multi-axis machine
generates more noise than a single-axis machine. Therefore, multi-axis
machines may require additional noise reduction techniques, such as a
metal enclosure or clamping of cables shields to an RF ground.