Installation manual
44
2.8.8
J13
F )+&.&!+
1 1
F ' : F ' )HH8
F '! $ F ' A$(
F ' 1 F ' ,EDH8
F ' 8DD88/H F '! /8=A
F ' ,EDH8 F ' /8='
F '# /8=RA F ' /8=9A
F '" /8=R' F ' /8=9'
F ' )H
J13-1
CU
CU (Commutation Phase U) input when using open collector Hall feedback.
This input has a 2.21 k pull-up resistor to 3.3 volts.
J13-2
CV
CV (Commutation Phase V) input when using open collector Hall feedback.
This input has a 2.21 k pull-up resistor to 3.3 volts.
J13-3
CW
CW (Commutation Phase W) input when using open collector Hall feedback.
This input has a 2.21 k pull-up resistor to 3.3 volts.
J13-4
NC
No connect
J13-5
I/O RTN
This terminal is the return connection for the 5 VDC supply. I/O return is
internally connected to PTC return. An inner feedback cable shield can be
connected to this point. Outer shields should connect to the shell which is
PE.
J13-6
CH Z +
J13-7
CH Z -
The CH Z differential input. The minimum pulse width is 250 ns.
J13-8
PTC
J13-9
PTC RTN
The PTC input has a trip point at 2200 .
If a PTC is not used, PTC must be wired to PTC return.
PTC return is internally connected to I/O return
J13 –10
+5 VDC
This terminal provides a 5 VDC output to power an external command
encoder, if necessary. The load current should not exceed 200 mA.
J13-11
I/O RTN
This terminal is the return connection for the 5 VDC supply. I/O return is
internally connected to PTC return. An inner feedback cable shield can be
connected to this point. Outer shields should connect to the shell, which is
PE.
Shell
Outer shield connection (wired to PE in the drive).