Installation manual
37
2.8.2
Base Drive Unit Outputs
General
Purpose
Outputs
J4-6,7
DOUT1
FAULT
J4-8,9
DOUT2
RUN
DOUT1 and DOUT2 are optically isolated outputs that provide information
about the state of the drive. The outputs are Darlington phototransistors with a
33 volt zener diode wired in parallel to clamp voltage transients.
33V
33V
J4-6
DOUT1-
J4-7
DOUT1+ (FAULT)
J4-8
DOUT2-
J4-9
DOUT2+ (RUN)
The following table lists the maximum output rating.
<-#0
$(
<
-
"
$
!$
66
;
##0 $5
CAUTION
The outputs are not short circuit protected. Configure the application to ensure
the maximum current is not exceeded.
The list below describes the factory defaults for each of the outputs.
*&
6*(
&NH&--+&@:JH&+1&&+
*-5%&---1&&+
-5*%&---
*
*"
NH&--+&:8&+1&&+
*%-55%&---1&&
+-5%5*&---
H&--*&&+5-&