Manual

Dan Wesson Firearms Revolver Instruction Manual

Small Frame Models

DIRECTIONS FOR REPLACING BLADE

Using the Barrel Wrench Tool, remove retaining screw on top of Sight Body.

Holding sight with head of Windage Screw,pull Rear Blade and Screw as a unit, out of Body. Take care not to lose

Detente Plunger and Spring which is positioned under Windage Screw Head.

3. Insert Windage Screw into Rear Blade approximately central with Blade.

4 Insert Blade and Screw into Rear Sight Body. Be sure Detente Plunger and Spring are in proper position under

Windage Screw Head.

5. Install Retaining Screw and adjust Sight as required.

FRONT SIGHT

CAUTION: BE SURE REVOLVER IS NOT LOADED BEFORE ATTEMPTING TO CHANGE

FRONT SIGHT BLADES

On Dan Wesson target revolvers incorporating a replaceable front sight blade:

To change front sight blades, unscrew the front sight retaining screw (40) at the end of the shroud, approximately one-eight

of an inch. Push the front sight blade forward and lift up removing from the shroud. To install a new blade, place rear

dovetail on bottom of sight blade under front sight pin (6) and retighten the retaining screw.

Note: Do not over tighten retaining screw.

GRIPS

CAUTION: BE SURE REVOLVER IS NOT LOADED BEFORE ATTEMPTING TO CHANGE

GRIPS.

To change grip, unscrew the grip screw (52) on bottom of grip. Slide grip off tang and remove screw from grip. Slide

replacement grip on tang and replace screw. Tighten only until grip is snug and free from any movement.

SERVICING AND REPAIR

Should your Dan Wesson revolver require service or repair, make certain it is NOT LOADED and send it to Dan

Wesson Firearms Co.. Inc. where competent gunsmiths can quickly make the necessary repairs. In illustrated

parts breakdown is included in this booklet to help you identify the component parts of the revolver.

Accessory items and parts are available from your dealer. However, it the item you require is not normally

stocked, the dealer can order it from our many Dan Wesson Accessory Products or Authorized Parts

Distributors. Please place your order with your dealer and do not contact distributors directly. To do so would

delay your order as the distributor must work through a dealer only.

IMPORTANT

Any repair or parts replacement with exception of items indicated with an asterisk (*) should be performed by

Wesson Firearms. Wesson Firearms will not assume responsibility for proper functioning of this revolver if

unauthorized alterations, adjustments or parts replacements with unauthorized parts are made.