User Guide

Table Of Contents

Dugan Model N User Guide

Although you probably will not need to set a Sync source manually, you can do this

by selecting the desired source and pressing ENTER.

NOTE: The INTERNAL Sync source setting (48k only) is provided for test purposes. The Dugan

is not normally used as the sync master.

Select 8 or 16 for the # ADAT CHANNELS. Linking is not available in 16 mode.

Note that when Dante is selected, the ADAT output channels mirror the first 8 or 16

Dante inputs. Conversely, when ADAT is selected, the Dante output channels mirror

the first 8 or 16 ADAT inputs.

The settings of the back panel switches are indicated, but they cannot be changed here.

Dante Configuration Screen

This screen lets you choose which Dante channels to use with this device, and the

functions of the four network connectors.

Figure 8-6 Dante Configuration screen

Selecting Factory Defaults sets the Start Channel # to 1 and # of Channels to the maxi-

mum allowed by the current sample rate.

Highlight Start Channel # or # of Channels and turn the knob to set that parameter.

Network Modes

The four network connectors can be reassigned to enact different network functions.

Each option is discussed in the sections below.

Highlight the Network Mode and turn the knob to select the desired mode. Each mode

is shown as a set of abbreviated labels for the four connectors. For example, in Figure

8-6, the Network Mode is Dante Primary, Dante Secondary, Control, Control.