User Guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Theory of the Speech and Music Systems
- Chapter 3: Quickstart
- Chapter 4: Installation
- Chapter 5: Connecting to a Computer
- Chapter 6: Dugan Control Panel Software
- Chapter 7: Pre-fader Insert
- Chapter 8: Dugan Music System and Gain Limiting
- Chapter 9: Front Panel
- Chapter 10: Updates
- Appendix A: Connector Pinouts
- Appendix B: Specifications
Dugan Model E-3A User Guide Updates
76
Figure 10-1 Dugan Utility
If you do not see the Dugan unit(s) on your network in the list,
see Connecting to a Computer on page 27.
5. Select the unit to update from the list.
6. Make sure Use DHCP is NOT selected for that unit.
Under certain network conditions, DHCP is not compatible with the firmware
update process.
7. If you have deselected Use DHCP, click on Send New Params To Unit.
The unit reboots.
8. Click Update Firmware.
The unit reboots after the update completes.
9. Repeat steps 5 through 8 for each unit you wish to update.
NOTE: To force an update when the Update Firmware button is not blue, Ctrl-click the button.
NOTE: If the firmware update process fails, your unit may not pass audio. To recover from this
condition, repeat steps 5 through 8 above, but Ctrl-click the Update Firmware button.