User Guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Theory of the Speech and Music Systems
- Chapter 3: Quickstart
- Chapter 4: Installation
- Chapter 5: Connecting to a Computer
- Chapter 6: Dugan Control Panel Software
- Chapter 7: Pre-fader Insert
- Chapter 8: Dugan Music System and Gain Limiting
- Chapter 9: Front Panel
- Chapter 10: Updates
- Appendix A: Connector Pinouts
- Appendix B: Specifications
Dugan Model E-3A User Guide Front Panel
69
Sync Source
The Sync source is automatically set to AES or ADAT based on the selected mode. How-
ever, if a word clock signal is detected at WORD CLOCK IN, the Sync source is automatically
set to WDCLK.
Although you probably will not need to set a Sync source manually, you can select
the desired source and press ENTER.
NOTE: The INTERNAL Sync source setting is provided for test purposes only. The Dugan is not
normally used as the sync master.
Network Setup Screen
This screen lets you configure the control network parameters for this device. Connect
your Dugan Control Panels to this port.
Figure 9-9 Network Setup screen
Select DHCP which asks a router to automatically supply valid IP Address, Netmask, and
Gateway values.
If you wish to set the IP address settings manually, navigate to each three-digit group
and turn the knob to change the value.
When you click MENU to exit, if you made any changes a dialog appears. Click CANCEL
to discard changes or APPLY to save them.
See Chapter 5: Connecting to a Computer to troubleshoot network settings.