User Guide

Dugan Model E-3A User Guide Installation
26
To check or change the word clock source:
1. Use the front panel to go to MENU.
2. Select Channels Setup.
3. Navigate to the right to the field under Sync.
4. Rotate the knob to select the desired source.
WORD CLOCK IN
is unterminated when shipped. If you are receiving word clock over a
very long cable (> 20 ft), remove the top lid and move the switch to ON (see below)
.
Figure 4-3 Word clock input termination switch
Power
A power connector accepts a locking power cable. In an emergency, the Model E-3A
can accept power supplies within the range 12–24 VDC, 2 A (minimum), center pin
positive.
Mix Matrix Outputs
An internal mix matrix can route processed or unprocessed inputs to six mix buses
that can be assigned to any audio outputs.
For more information on using mix buses, see Mix Buses on page 49.