User guide

Dugan Model E-3 User Guide Dugan Control Panel
33
Add Units Manually
To add a unit manually with a known IP address, click the + sign at the right of the
Top Pane and enter the IP address in the dialog that appears.
To add a unit manually without a known IP address:
1. Power down the Model E-3.
2. Hold down Channel 1’s mute button and power up the unit.
This performs a network reset.
3. Click the + sign at the right of the Top Pane.
4. Enter the default IP address: 192.168.1.xx
xx = last two digits of serial number, unless they are 00, in which case enter 100.
5. Click OK to exit the dialog.
To display a unit’s IP address, hover the mouse over the unit’s name.
Select Units to Display
The Model E-3 is set up by default to find all available units connected to the network
automatically. Some facilities have multiple studios on the same network that oper-
ate independently. In that case, you may want to restrict the units shown in the Top
Pane to those in your studio. To do this:
1. Hover the mouse cursor over the names of the units that you want to display, and
note their IP addresses.
2. Ctrl-click on the + sign at the right of the Top Pane.
The + sign turns red.
3. Quit and relaunch the Dugan Control Panel.
It opens with Auto Detect Disabled in the Top Pane
4. Click on the red + sign, and enter the IP address of the first unit you want to add.
5. Repeat step 4 until your units all appear in the Top Pane.
Manually added units must also be removed manually. To remove manually added
units from the Top Pane, shift-click on the
+ sign. A dialog appears to confirm that
they have been removed.
To restore automatic detection, ctrl-click on the + sign, which turns white.