User's Manual

Doc. No.
Rev.
Date
DRAFT
1.01
2012-01-27
Damm Cellular Systems A/S, Denmark
TetraFlex
®
7.5 Manual - BS421 Configuration
TetraFlex® 7.5 Manual 2-66
NB: Update only NK.BIN and Boot.ini if you are adviced to do so (in case they are damaged
or need to be updated).
Installation of NK.bin file (Windows CE): Refer to section 2.6.2.1
Installation of the Boot.bin file:
o Copy the Boot.bin file to the root of the TR421 CF-Card.
o Restart the TR421 with the command
99/RESTART
o Reboot the TR421 with command to the PS421, commands
AP (Address the Power supply)
11- (power off for TR1 and TR3
11+ (power on for TR1 and TR3)
12- (power off for TR2 and TR4)
12+ (power on for TR2 and TR4)
2.6.2 Installing Windows CE on BS421
The operating system on BS421 is Windows CE that is contained in one file - NK.bin this
chapter describes how to install it.
IMPORTANT:
Do not copy NK.bin (WinCE) to the BS421 unless instructed to do so, or forced to do
so due to breakdown.
2.6.2.1 Copy NK.bin (WinCE) to BS421
If the BS421 is connected with VNC, the BS application (TR421) MUST be stopped before
copying files. Enter 99/STOP <Enter> in the OM Command Interpreter and the application
stops and shows the normal WinCE desktop
WARNING: If the BS application is not stopped before copying, the connection to the
BS421 may be lost. In this case proceed as follows:
o Disassemble the BS421
o Take out the CF-Card
o Put the CF-card into an compatible card reader
o Manually copy the NK.bin file to the CF card
o Put the CF-card back in the BS421
o Reassemble the BS421 and proceed as described in section 2.6.2.2
If communication with BS421 is present, proceed as follows