Technical data
INSTALLATION INSTRUCTIONS
1. Cut the aperture to the dimensions shown below or use the template if printed on the packaging.
2. Invert the Hob and apply the sealing agent provided to match the outer perimeter edge.
3. If the sealing agent is a strip type, the protective covering must be removed from both sides.
Do not leave a gap in the sealing agent or overlap the thickness.
NOTE: do not use any Silicone based sealant, as this can damage the worktop surface if
repairs are required.
4. Insert the appliance into the aperture and fix in position via the clamps & screws, tightening
the screws evenly (see fig. below).
MODEL
A
B
C
D
E
DCG6W
560 480 500 585 30
DCG6S
560 480 500 585 30
DCG6FS
560 480 500 585 30
DCG64WS
560 480 500 585 30
DCG64WFS
560 480 500 585 30
DCG75WS
560 480 500 685 30
DCG75WCS
560 480 500 685 30
DCG95WS
830 480 500 860 30
DCG95WCS
830 480 500 860 30
DACG7501
560 480 510 740 30
DACG7502
560 480 501 740 30
INSTALLATION NOTES
HOB APERTURE DIMENSIONS
9