User`s manual

4M30 Camera User’s Manual 7
DALSA 03-32-10030-03
Specification Grade 02
e) Maximum size of clusters (adjacent pixels) 30
f) Blemish pixel deviation from VFLL* under illumination >10% <45%
g) Blemish pixel deviation from average dark level, measured at dark >20mV
Notes:
*VFLL is defined as the output signal under broadband quartz tungsten halogen light
with an irradiance of 4.08µW/cm
2
.
1. All sensors are tested in four output mode – 1x gain.
2. Blemish variations are measured over an entire frame of data and counted within the
frame boundaries defined by a) and b).
3. Blemishes are defined as a pixel or group of pixels with an output as defined in f) or
g).
4. Clusters are defined as a pixel or group of pixel blemishes, and are allowed, provided
they are smaller or equal to the sizes specified in e).
5. Illuminated blemish analysis done at 70% of VFLL (2.86µW/cm
2
).
6. Column and row defects not permitted.
7. Better than grade 02 sensors may be available. Please contact DALSA sales if
interested.
1.3 Camera Performance Specifications
Table 3: 4M30 Camera Performance Specifications
Physical
Characteristics
Units Notes
Resolution H x V pixels 2048x2048
Pixel Size µm 12x12
Pixel Fill Factor % 100
Size mm 146x92x14
3
Mass kg 1.3
Power Dissipation W < 24
Lens Mount F mount
Aperture mm 24.6 x 24.6
Operating Ranges Units
Min. Max.
Frame Rate Fps 30
Data Rate MHz 4*40 4*40
Data Format LVDS 4*12 bit
Responsivity DN/(nJ/cm
2
) 24@530nm 4
Operating Temp °C 10 40
+15 Input Voltage V +14.925 +15.075
+5 Input Voltage V +4.975 +5.025