User`s manual

4M Stop Action Camera Manual PRELIMINARY
61
set analog offset
sao t
.
n. Allowable value is 0
for all taps.
alog offset value. Allowable
i
Set the analog gain
t = Tap selectio
i = An
range is
0 -1023.
set baud rate
sbr m
n port. Baud rates:
9600,
19200 57600, and 115200. Default
Set the speed of the serial
communicatio
,
baud: 9600
set exposure mode
sem m
ode. Available
programmable frame
osure time using
commands
and set. Exposure
d (ECE).
NC, maximum exposure
control disabled
)
C. Exposure control
mable SYNC,
ure time, exposure
led (ECD)
Set the exposure m
values are:
2: Internal SYNC,
rate and exp
ssf
control enable
3: External SY
time, exposure
(ECD
4: Smart EXSYN
enabled (ECE).
a
7: Internal program
m ximum expos
control disab
set exposure tim
set f
e Sets the exposure time to a floating
point number in µs. Allowable range is
10-999989 µs in increments described
in Table 11: Allowable Exposure Time
Increments on page 27.
set sync frequency
ssf f
ate in Hz to a value
62.1 (4M60 full frame) or 1
half frame).
Sets the frame r
from
1 to
to 31 (4M30
set system gain
ssg t
Sets the digital gain.
tion. Allowable value is 0
ue is specified from 0 to
digital video values ar
by this number.
i
t = Ta se
for all tap
i = Ga
65535. Th
multiplied
p lec
e
s.
in val
e
set video mode
svm m
ts the camera’s video mode.
ideo mode
pattern checkerboard
2
3: Test pattern alternating line 2
4: Test pattern horizontal ramp
5: Test pattern vertical ramp
6: Test pattern diagonal ramp
7: Test pattern FPN
8: Test pattern PRNU
9: Test pattern fixed 1023
10: Test pattern fixed 255
Se
0: V
1: Test
: Test pattern alternating line 1
DALSA 03-32-10121-09