User`s manual

4M Stop Action Camera Manual PRELIMINARY
53
Dark Patches
If dark patches appear in your output the optics path may have become contaminated.
Clean your lenses and sensor windows with extreme care.
iltered blow bottle or dry, filtered compressed air.
her alcohol or
the moistened end first,
followed by the rest of the pad. The dry part of the pad should follow the moistened
the window surface, as
this will end up leaving residue and streaking behind.
7. Repeat steps 2-4 using a clean tissue until the entire window has been cleaned.
8. Blow off any adhering fibers or particles using dry, filtered compressed air.
1. Take standard ESD precautions.
2. Wear latex gloves or finger cots
3. Blow off dust using a f
4. Fold a piece of optical lens cleaning tissue (approx. 3" x 5") to make a square pad that
is approximately one finger-width
5. Moisten the pad on one edge with 2-3 drops of clean solvent—eit
acetone. Do not saturate the entire pad with solvent.
6. Wipe across the length of the window in one direction with
end. The goal is to prevent solvent from evaporating from
DALSA 03-32-10121-09