User`s manual

4M Stop Action Camera Manual PRELIMINARY

3.7 Offset and Gain Adjustments

tting

Purpose: Sets the analog offset. The analog offset should be set so that it is at

least 3 times the rms noise value at the current gain. The analog

offset is factory calibrated and is applicable to exposure mode

sem 2/4 but no calibration is assumed for exposure mode

sem 3/7.

Syntax:

Syntax Elements:

all taps.

e. Extreme range is 0 -511 but dynamic

range is dependent of the camera’s current exposure mode

Notes:

r values. A value of 100

does not equal an offset of 100DN.

camera to digitally

the output image.

• The resulting analog offset value depends on other camera

parameters such as temperature, frame rate, and exposure

mode.

• The upper input limit of the offset remains the same regardless

of the exposure mode.

t limit of the offset for sem 3/7 is set at 24 and

s set at 0.

Example:

sao 0 20

exposure mode

sem 3/7.

Se Analog Offset

sao t i

Tap selection. Allowable value is 0 for

Analog offset valu

and gain settings.

• The offset increases linearly with highe

• Entering a large value offset will cause the

saturate

• The lower inpu

for sem 2/4 i

ed for

Factory Calibrated Analog Gains

The camera has a factory calibrated analog gain setting. Adjustment of analog gain is not

available to the user, however, digital gain is available as set system gain

ssg.

The calibration is applicable to exposure mode

sem 2/4 but no calibration is assum

DALSA 03-32-10121-09