User`s manual

4M Stop Action Camera Manual PRELIMINARY
31
thW Control Signals
X C f g
TBD TBD
LEV Window Level Hold Time- The Window
must remain valid and constant after the E
edge for at least the thWLEV time.
SYN allin
tsWLEV Window Level Set Time- The Window Control Signals must
remain valid and constant at least tsWLEV before the
EXSYNC falling edge.
TBD TBD
Toggling Window Sequences Using a Software
Trigger
Purpose: rdinates, the camera
of window coordinates. These
coordinates wait for a trigger and because they have been
preprogrammed, the new window is activated extremely quickly.
This command loads a new window sequence.
Syntax:
m
from 0 to 1 (or vice
nce being used.
Related Com a
Example:
Notes:
tween the issue of the wss command and the
time when the new window sequence is triggered (Figure 18)
• When toggling windows, the camera discards the first frame
is prevents the camera from
sending out erroneous data.
• Upon power up or reset of camera, the camera assumes that a
wss 0 has already been executed
elay for New Window to Become Active when Using wss Command
To allow quick activation of n
allows you to preset one sequence
ew window coo
wss m
Syntax Elements:
Window sequence trigger where changing
versa) toggles the current wind eow sequ
m nds:
wts
wss 0
• There is a delay be
read out after the toggle. Th
Figure 18: Time D
wss
value
Curr ent W indow Sequence N ew W indow Sequence
tDelay
Ser ial Communic on
Window Sequen
Exsync
ati
ce
Table 14: Timing Parameters
tDelay This is the time delay that occurs to decode the
wss command.
TBD TBD
DALSA 03-32-10121-09