User`s manual

ManualsBrandsDalsa ManualsDigital CameraSpyder3 S3-14-02k40-00-R

74 Spyder3 S3-14 and S3-24 User's Manual

03-032-20117-00 Teledyne DALSA

Mnemonic

Syntax

Parameters

Description

set cable parameter

scb

Set the cable parameter. Output compare value.

Available values are: 0-255.

set ccd direction

scd

Sets the CCD shift direction where:

0 = Forward CCD shift direction.

1 = Reverse CCD shift direction.

2 = Externally controlled direction control via CC3.

(CC3=1 forward, CC3=0 reverse.)

set digital offset

sdo

t i

Subtracts the input value from the video signal prior to

FPN correction.

t = tap selection, either 1 or 2 depending on camera

model, or 0 for all taps.

i = Offset in a range from 0 to 2048DN.

set exposure mode

sem

Sets the exposure mode:

2 = Internal SYNC, internal PRIN, programmable line

rate and exposure time using commands ssf and set

3 = External SYNC, internal PRIN, maximum exposure

time

4 = Smart EXSYNC

5 = External SYNC and PRIN

6 = External SYNC, internal PRIN, programmable

exposure time

7 = Internal programmable SYNC, maximum exposure

time. Factory setting.

8 = Internal SYNC, internal PRIN, programmable

exposure time. Maximum line rate for exposure time.

set exposure time

set

Sets the exposure time. Refer to the camera help screen

(h command) for allowable range.

set fpn coeff

sfc

x i

Set the FPN coefficient.

x =pixel number within the range 1 to sensor pixel

count.

i= FPN value within the range 0 to 2047 (12-bit LSB).

set input LUT

sil

t i

Set a single value in a LUT.

t=Tap: 1 or 2.

i=Value within the range -255 to +256.

set lower threshold

slt

The pixels below the lower threshold are checked for

and reported in the end-of-line sequence in a range from

0-4095.

set mirroring mode

smm

0 - 1

set prnu coeff

spc

x i

Set the PRNU coefficient.

x=pixel number within the range 1 to sensor pixel

count.

i= PRNU value within the range 0 to 28671.

set readout mode

srm

Set the readout mode in order to clear out dark current

charge in the vertical transfer gates before the sensor is

read out.

0 = Auto.

1 = Dark current clear.

2 = Immediate readout. Does not clear dark current.