User`s manual

72 Spyder3 S3-14 and S3-24 User's Manual
03-032-20117-00 Teledyne DALSA
Mnemonic
Syntax
Parameters
Description
enable (EXSYNC) jitter
ejt
i
0 – 1. This feature will prevent line-to-line output
variations due to EXYNC jitter at the maximum line rate.
end of line sequence
els
i
Sets the end-of-line sequence:
0: Off
1: On
enable noise correction
enc
i
0 – 1. Enables FIR filter in the output. The first two pixels
are not filtered.
enable pixel coefficients
epc
i i
Sets whether pixel coefficients are enabled or disabled.
The first parameter sets the FPN coefficients where i is:
0 = FPN coefficients disabled
1 = FPN coefficients enabled
The second parameter sets the PRNU coefficients where
i is:
0 = PRNU coefficients disabled
1 = PRNU coefficients enabled
enable shaft encoder
ese
i
0 - 1
enable watchdog
ewd
i
0 – 1. The watchdog subtracts excessive dark current at
line rates below 10 Hz.
get camera model
gcm
Reads the camera model number.
get camera parameters
gcp
Reads all of the camera parameters.
get camera serial
gcs
Read the camera serial number.
get camera version
gcv
Read the firmware version and FPGA version.
get exposure mode
gem
Retrieves the current camera exposure mode.
get exposure range
ger
get fpn coeff
gfc
x
Read the FPN coefficient
x = pixel number to read in a range from 1 – sensor
pixel count.
get help
gh
Retu rns all of the available ―get‖ commands.
get input LUT
gil
Display the current LUT set number.
get line
gl
x x
Gets a line of video (without pixel coefficients applied)
displaying one pixel value after another and the
minimum, maximum, and mean value of the sampled
line.
x = Pixel start number
x = Pixel end number
in a range from 1 to sensor pixel count.
get line average
gla
x x
Read the average of line samples.
x = Pixel start number
x = Pixel end number
In a range from 1 to sensor pixel count.
get prnu coeff
gpc
x
Read the PRNU coefficient.
x = pixel number to read in a range from 1 – sensor
pixel count.