User`s manual

Spyder3 S3-14 and S3-24 User's Manual 69

Teledyne DALSA 03-032-20117-00

Voltage Measurement

The command vv displays the camera’s input voltage. N ote that the voltage measurem ent featu re of the

camera provides only approximate results (typically within 10%). The measurement should not be used to

set the applied voltage to the camera but only used as a test to isolate gross p roblems with the supply

voltage.

Camera Frequency Measurement

Returns the frequency for the requested Camera Link control signal

Camera Link Command

Parameter

Description

Notes

gsf i

Camera Link control signal to

measure:

1: CC1 (EXSYNC)

2: CC2 (PRIN)

3: CC3 (CCD Direction)

 Camera operation may be impacted when

entering the gsf command (i.e., poor time

response to direction change or video may have

artifacts (gain changes) for several lines while

the camera returns signal information)

This command is not available when operating the

camera with external CCD direction control (scd

Example

gsf 1