User`s manual

Spyder3 S3-14 and S3-24 User's Manual 63
Teledyne DALSA 03-032-20117-00
Write Input LUT
Saves current values of input LUT that are in FPGA SDRAM to Flash memory or a PC file.
Camera Link Command
Parameter
Description
Notes
wil
0 = Factory set
1 to 4 = User sets
 LUT use is enabled or disabled with the
EIL command.
 Set 0 can only be written from factory
mode.
Example
Saving and Restoring PRNU and FPN
Coefficients
Saving the Current PRNU Coefficients
The wpc command saves the current PRNU coefficients. You can save u p to four sets of pixel coefficients.
Camera Link Command
Parameter
Description
Notes
wpc i
PRNU coefficients set to save.
1 = Coefficient set one
2 = Coefficient set two
3 = Coefficient set three
4 = Coefficient set four
Example
wpc 2
Saving the Current FPN Coefficients
The wfc command saves the current FPN coefficients. You can save up to four sets of pixel coefficients
Camera Link Command
Parameter
Description
Notes
wfc i
FPN coefficients set to save.
1 = Coefficient set one
2 = Coefficient set two
3 = Coefficient set three