User`s manual

44 Spyder3 S3-14 and S3-24 User's Manual
03-032-20117-00 Teledyne DALSA
Select Cable
Sets the cable parameters.
Camera Link Command
Parameter
Description
Notes
scb i
Output compare value. Available
values are: 0 to 255.
 In medium configuration, both cables must be
the same length.
 Only one copy of this setting is saved in the
camera (rather than with each setting).
 On the lfs (load factory settings) command the
cable length will be set to the factory default of
100.
 The cable parameter is a relational value.
Increase the value for longer cables, and
decrease it for shorter ones.
 Adjust the value until the test p attern (svm 1) is
clean.
 get scb returns the current cable parameter.
Example
scb 75
Sensor Output Format
Sensitivity Mode
Sets the camera’s sensitivity m od e. When u sing high sensitivity m od e, the cam era’s responsivity
increases. High sensitivity mode permits much greater scanning speeds in low light, or allows reduced
lighting levels.
Camera Link Command
Parameter
Description
Notes
ssm i
Sensitivity mode to use.
0 = Low sensitivity mode
1 = High sensitivity mode
2 = Tall pixel mode
 To obtain the current sensitivity mode, use the
command gcp or get ssm.
 The scd (set ccd direction) command is not
available in low sensitivity mode or tall pixel
mode.
Example
ssm 0