User`s manual

32 Spyder3 S3-14 and S3-24 User's Manual
03-032-20117-00 Teledyne DALSA
Saving and Restoring Settings
Use these commands to select, load, and save factory, user, and coefficient sets.
Camera Link Commands
Parameter
Description
lpc i
Loads your previously saved pixel coefficients from non-volatile memory to active status. 0:
factory calibration. 1 – 4: user sets.
rfs
Restores the camera’s factory settings. The FPN and PRNU coefficients are reset to 0.
rus
Restores the camera's last saved user settings and FPN and PRNU coefficients.
wfc i
Write all current FPN coefficients to non-volatile memory. 1 – 4 available sets.
wil i
Write current LUT’s to non -volatile memory. 1- 4 available sets.
wpc i
Write all current PRNU coefficients to non-volatile memory. 1 – 4 available sets.
wus
Write all of the user settings to non-volatile memory.
For each camera operating mode (high sensitivity forward direction, high sensitivity reverse direction,
low sensitivity, or tall pixel), the camera has distinct factory settings, current settings, and user settings. In
addition, there is one set of factory pre-calibrated pixel coefficients and up to four sets of user created
pixel coefficients for each operating mode.
4 sets of user
pixel coefficients
User
Settings
Current
Session
wus wpc,wfc,
rus lpc,
Factory
Settings
1 set of factory
pixel coefficients
For each camera operating mode:
Low Sensitivity
High Sensitivity Forward
High Sensitivity Reverse
Tall Pixel
Figure 14: Saving and Restoring Overview