User`s manual

Piranha4 4K and 2K Dual Line Monochrome CMOS Camera User's Manual 57
Teledyne DALSA 03-032-20176-02
Camera Control Feature Descriptions
The following table describes these parameters along with their view attribute and minimum camera
firmware version required. Additionally the firmware column will indicate which parameter is a
member of the DALSA Features Naming Convention (DFNC), verses the GenICam Standard Features
Naming Convention (SFNC not shown). The Device Version number represents the camera software
functional group, not a firmware revision number.
Display Name
Feature
Description
Device
Version
& View
Internal Line
Rate
AcquisitionLineRate
Specifies the camera internal line rate, in Hz
when Trigger mode set to internal.
Note that any user entered value is
automatically adjusted to a valid camera value.
1.00
Beginner
Measured Line
Rate
measureLineRate
Specifies the line rate provided to the camera by
either internal or external source (RO)
1.00
Beginner
Refresh
measured line
rate
refreshMeasureLineRate
Press to show the current line rate provided to
the camera by either internal or external sources
1.00
Beginner
Exposure Time
Source
ExposureMode
Sets the operation mode for the camera‘s
exposure (or shutter). (RO)
1.00
Beginner
Timed
Trigger Width
Timed
TriggerWidth
The exposure duration time is set using the
Exposure Time feature and the exposure starts
with a LineStart event.
Uses the width of the trigger signal pulse to
control the exposure duration.
TDI Stages
1
2
sensorTDIStageSelection
1
2
Selects the number of lines to be imaged
Single Line
Two lines summed together
1.00
Beginner
DFNC
Multi Line
Exposure
Mode
ON
OFF
multiLineExposureMode
ON
OFF
Selects Multi Line exposure mode
For independent exposure control of each line
For TDI stage = 1, 2 or Area mode
1.00
Beginner
DFNC
Exposure Time
Selector
All
Top Line
Bottom Line
exposureTimeSelector
All
TopLine
BottomLine
Used to select where ExposureTime is applied
to.
Both lines get equal exposure time
Allows the top line to have exposure time set
Allows the bottom line to have the exposure
time set.
1.00
Beginner
DFNC
Exposure Time
ExposureTime
Sets the exposure time (in microseconds) when
the Exposure Mode feature is set to Timed.
1.00
Beginner
Measured
Exposure Time
measureExposureTime
Specifies the exposure time provided to the
camera by either internal or external source (RO)
1.00
Beginner
Refreshed
measured
exposure time
refreshMeasureExposureTime
Press to display the current exposure time
provided to the camera.
1.00
Beginner