User`s manual

94 Piranha4 2K and 4K Camera Color User's Manual
03-032-20180-02 Teledyne DALSA
Acquisition and Transfer Control Category
The P4 Acquisition and Transfer controls, as shown by CamExpert, groups parameters used to configure
the optional acquisition modes of the device. Parameters in gray are read only, either always or due to
another parameter being disabled. Parameters in black are user set in CamExpert or programmable via an
imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or third
party software usage—not typically needed by end user applications.
Acquisition and Transfer Control Feature Descriptions
The following table describes these parameters along with their view attribute and minimum camera
firmware version required. Additionally the firmware column will indicate which parameter is a
member of the DALSA Features Naming Convention (DFNC), verses the GenICam Standard Features
Naming Convention (SFNC not shown).
Display Name
Feature
Description
Device
Version
& View
Device
Registers
Streaming Start
DeviceRegistersStreamingStart
Announces the start of registers streaming
without immediate checking for
consistency.
1.00
Beginner
DFNC
Device
Registers
Streaming End
DeviceRegistersStreamingEnd
Announces end of registers streaming and
performs validation for registers
consistency before activating them.
1.00
Beginner
DFNC