User`s manual

82 Piranha4 2K and 4K Camera Color User's Manual
03-032-20180-02 Teledyne DALSA
Flat Field Category
The P4 Flat Field controls, as shown by CamExpert, group parameters used to configure camera pixel
format, and image cropping. Additionally a feature control to select and output an internal test image
simplifies the process of setting up a camera without a lens.
Parameters in gray are read only, either always or due to another parameter being disabled. Parameters
in black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or third
party software usage—not typically needed by end user applications.
Flat Field Control Feature Description
The following table describes these parameters along with their view attribute and minimum camera
firmware version required. Additionally the firmware column will indicate which parameter is a
member of the DALSA Features Naming Convention (DFNC), verses the GenICam Standard Features
Naming Convention (SFNC not shown).
The Device Version number represents the camera software functional group, not a firmware revision
number.
Display Name
Feature
Description
Device
Version
& View
Mode
flatfieldCorrectionMode
1.00
Off
Off
FPN and flat field coefficients
disabled.
Beginner