User`s manual

Piranha HS 4x User’s Manual 59
DALSA Corp. PRELIMINARY 03-32-10040-03
Error Codes
Code Description Suggested Cause
video level)
22 Analog gain calibration failure Analog gain calibration failure (could not
tune the analog gain to obtain targeted
video level)
23 CRC check failure while
attempting to restore the camera
settings
Camera setting will initialize to default
settings, since restore of USER/FACTORY
settings failed (internal micro EE memory
failure)
24 Camera settings not saved rus, rfs attempted but settings were not
saved
26 I2C communication fault while
accessing temperature sensor
Serial communication fault (I2C) while
accessing temperature sensor
27 Timeout waiting for DISC SYNC
to go LOW
Internal communication protocol error
Informal Message Codes
Code Description Suggested Cause
4 INFO: Flash memory ID error Reported from boot process, only if
DSP configuration fails (possible
cause: communication error with
serial flash memory )
8 INFO: DSP configuration file missing
or corrupt
Reported from boot process, only if
DSP configuration fails (possible
cause)
16 INFO: Serial communication failure
while accessing external ADC chip
Reported from boot process if
communication verification fails with
external ADC chip (camera voltage
measurement, SPI)
Monitoring Task Message Codes
Code Description Suggested Cause
1 WARNING: One or more voltages out
of specification
At least one of voltages is out of
specification
2 WARNING: Camera temperature
exceeds specified limit
Current camera temperature exceeds
specification limit
4 WARNING: External SYNC not
detected
Exposure Mode 3: external SYNC not
detected
16 WARNING: Analog gain is
over/under the specification
Current analog gain setting is out of
specification