User`s manual

38 Piranha HS 4x User’s Manual
03-32-10040-03 PRELIMINARY DALSA Corp.
Example:
To enable all monitoring tasks:
wed 0 1
Voltage Measurement
The command vv checks some of the camera’s input voltages and internal voltages
during power-up. If they are within the proper range, the camera returns OK>.
Otherwise, the camera returns an error message. Note that the voltage measurement
feature of the camera provides only approximate results (typically within 10%). They
should not be used to set the applied voltage to the camera. The purpose of this test is to
isolate gross problems with the supply voltages.
Temperature Measurement
The command vt measures and displays the temperature of the inside of the camera. It
helps to determine whether the camera is operating within the recommended front plate
temperature range of 10 to 50°C.
3.14 Rebooting the Camera
The command rc reboots the camera. The camera starts up with the last saved settings.