User`s manual

Piranha HN RoHS User Manual
Teledyne DALSA 03-032-20135-01
55
GCP Screen
Description
Camera Model No.:
HN-xx-xxxxx-xx-R
Camera model number.
Sensor Serial No.:
xxxxxxxxx
Sensor serial number.
Firmware Design Rev.:
xx-xx-xxxxx-xx
Firmware design revision number.
CCI Version:
xx-xxx-xxxxx-xx
Camera control information.
FPGA Version:
xx-xx-xxxx-xx
DSP design revision number.
SSN
0
Set Number
Video Mode:
video
Current video mode value set with the svm
command.
Number of Line Samples:
1024
Number of lines sample with the gla command
set with the css command.
Exposure Mode:
7
Current exposure mode value set with the sem
command.
SYNC Frequency:
5000.00 Hz
Current line rate. Value is set with the ssf
command.
CCD Direction:
internal/ forward
CCD shift direction set with the scd command.
Mirroring Mode:
0, left to right
Readout direction set with the smm command.
Analog Horizontal Binning
1
Horizontal binning value set with the sbh
command.
Analog Vertical Binning
1
Vertical binning value set with the sbv command.
Digital Horizontal Binning
Digital Vertical Binning
Stage Selection
96
Number of integration stages set with the stg
command.
TDI Mode:
tdi
Current operating mode, either TDI or Area set
with the tdi command.
Region of Interest:
(1,1) to (8192,1)
Region of interest size set with the roi command.
Camera Link Mode:
21, Full, 8 taps, 8
bits, no time MUX
Camera Link configuration set with the clm
command.
Output Throughput:
320
Camera throughput value set with the sot
command.
Reference Gain (dB):
0.0 0.0 0.0 0.0
Analog reference gain set with the ugr command.
System Gain:
0
Digital gain settings set with the ssg command.